There are many home renovation procedures and many details. It is understood that wallpaper construction may be the last process of hard decoration of the home decoration, the start of smooth decoration. Wallpapers should be completed in every hardware such as woodworking, paint, water and power, plastering, and after a sanitary cleaning.

Ground and skirting are installed
❖ Avoid smashing the keel, sawing wood, etc. when laying the floor to help make the wallpaper dirty.
❖ Avoid vibration when setting up the baseboard, which causes the wallpaper to split up from the wall surface area, resulting in bubbling and curling of the wallpaper.
❖ Avoid a whole lot of dust pollution and bruises when reducing the baseboard.
❖General putty will not be approved at the bottom of the wall, the first wallpaper can not be cut neatly, very long time is prone to curling, causing the wallpaper to roll-up.
❖ Avoid kicking the skirting collection by sealing the wallpaper with cup glue, to ensure that the drinking water molecules in the wall Pure paper Wallpaper structure can not be discharged, resulting in mildew of the baseboard.
Following the kicking line is installed, it’s possible that the wall and the skirting line aren’t flat enough or have a gap. The post-installed wallpaper gets the effect of covering the gap.

Door cover and door are installed
First install the entranceway to avoid the wallpaper from being damaged and dirty, in fact it is also easy to repair the color. If the wallpaper is definitely patched and the paint is definitely repaired (the gap between the door cover and the wall and the gap between the skirting lines) will stain the wallpaper.
How big is the card may vary. If the size is certainly too small, the wallpaper will end up being attached first, and a blank will appear after the door is installed. If it’s full, it will very easily draw the wallpaper when the entranceway is installed, causing damage to the wallpaper.

Wood lacquer finish can’t be wallpapered first, then timber lacquer
❖Because the real wood lacquer is sprayed during construction, the paint will adhere to the wallpaper. So when the paint is definitely applied, the finished product should be protected. In particular, the encompassing wall of the cabinet, door, partition, etc. ought to be covered with a protective film. If it is atomized to the wall surface, the building quality of the wallpaper is not guaranteed, and it is simple to cause problems.

Air conditioning hole is well
❖ Avoid punching and damage the wallpaper.
❖ Avoid wall vibration when punching, leading to the wallpaper to fall off.
❖ Avoid dusting the wallpaper when punching.
Curtain rod hole is pre-made
The positioning of the curtain hanging rod support is smartly designed, and the hole is made to avoid the hole punching the top of wallpaper. Specifically for flocking, silk, deep embossing, special materials and various other hard-to-care wallpapers, be sure to pre-draw the curtain rod holes before pasting.

How to paste wallpaper?
Take away the wall skin: take away the original paint and other objects on the wall, make use of gypsum powder to fill the cracked section of the wall structure, and put a bandage after flattening; if it is sand gray wall structure, partition wall, it should be covered with cup cloth Or indeed great cloth; some low quality partitions or exterior walls to reach the insulation effect, need to be filled with plasterboard

Cut the wallpaper: first measure the height of the wall, then cut the amount of the wallpaper, generally there are two types of cases: simply no flower wallpaper according to the height of the wall is cut about 5 to 8 cm duration, as the upper and reduced trimming: the flower wallpaper must consider the design symmetry Sex, therefore the amount of the cut ought to be increased according to the actual situation, usually 8 to 10 cm longer.

Applying glue: Apply the wallpaper glue to the trunk of the cut wallpaper with a brush, pay special attention to the surrounding edges to end up being coated with glue to ensure the construction quality, the painted wallpaper, and the glue to handle the fold. 5- 10 minutes (remember that no external pressure should be applied to prevent creases in the wallpaper, especially the cloth). Following the glue is totally penetrated in to the paper, it could be posted, and several wallpapers are applied every time and posted in order. Special material wallpaper must be glued on the wall structure, such as velvet sound-absorbing wallpaper, gold foil tin wallpaper, etc.

Wallpaper building: Generally, the initial wallpaper is posted from the top to underneath of the door or the part of the corner. Utilize the squeegee from top to bottom, from the inside to the outside, lightly scrape the wallpaper, squeeze out the bubbles and excess glue to make the wallpaper smooth. Close to suspended ceiling 784421 340the wall.

Wallpaper structure: Generally, the initial wallpaper is posted from the very best to underneath of the door or the corner of the corner. Utilize the squeegee throughout, from the inside to the outside, lightly scrape the wallpaper, squeeze out the bubbles and extra glue to help make the wallpaper toned. Close to the wall.

Before wallpapering, switch off the power: When wallpapering, when you have a power switch or socket on the wall, you can turn off the main power, then cover the wallpaper with all the current power and socket, and cut two pairs from the center of gravity. The part series will show four small triangles, and then use the utility knife to eliminate the extra wallpaper around.

Trimming and cleaning: Take off the surplus wallpaper at the upper and lower ends. The edge of the knife ought to be sharp to avoid burrs. When reducing some wall coverings, it is best to make use of a Japanese imported blade with a price of just one 1.5 yuan. Then use a sponge dampened with drinking water to completely wipe the glue staying on the surface of the wallpaper to prevent the wallpaper from turning yellow. If the wallpaper is definitely dry following the wallpaper is dried out, use a knife to cut the injected glue and flatten it to eliminate it. it is good)